To change position of Room Sensor(s) you’ll need to:

1. remove them from your walls and then use the provided velcro strips to attach the Room Sensor(s) to their new location(s).
2. Make sure the new locations of your Room Sensors still follow recommendations here .

Once your Room Sensors are back on the walls you’ll need to :

1. Reset Point Mode calibration
2. Re-activate Point Mode and re-locate your items

Related articles

• Set up Room Sensors
• Active Point Mode and Locate items

Troubleshooting articles

• None of my Room Sensors is blue blinking when starting calibration
• Smart Remote cannot see my Charging Base
• Smart Remote cannot see one, two or three of my Room Sensors